<<< Date 22.03.2023 >>>
McLaren Automotive diagnostic software
For Model Speedtail 2019+:
Tyre Pressure Monitoring System (TPMS):
- TPMS Configuration
- TPMS Configuration Check
Transmission Control Unit (TCU):
- Un-pair immobilizer
- Align Vehicle Configuration
- Hydraulic Contamination Cleaning
- Transmission Replacement Reset
- Extended Snapshot Data
- Turbo Waste gate control
- Transmission calibration
<<< Date 10.03.2023 >>>
UDM Truck Tool
- Added new functionality - Scania Truck Blaupunkt Bosch radio code calculation - FREE for all customers of any UDM Truck tool activation. For more information you can check here: https://www.diagcode.com/udmtrucktool/
<<< Date 08.03.2023 >>>
McLaren Automotive diagnostic software
For Model Speedtail 2019+:
Power Doors Control Unit (PDCU):
- PDCU Calibration. For more information you can check here: https://www.diagcode.com/mclaren/
<<< Date 03.03.2023 >>>
GM 5-byte seed-key generator tool
- We has just released a GM 5-byte seed-key generator tool. For more information you can check here: https://diagcode.com/gmskgt/
<<< Date 02.03.2023 >>>
UDM Truck Tool
- Added new functionality - Decrypt the PIN code from the encryption key code - FREE for all customers of any UDM Truck tool activation For more information you can check here: https://www.diagcode.com/udmtrucktool/
<<< Date 24.02.2023 >>>
UDM Truck Tool
- Checksum correction of Flash for S6 ECU - FREE for all customers of Activation 1
- Checksum correction of Flash for EMD1, S8 ECU - FREE for all customers of Activation 2
- New Activation Added - Activation 4:
--- OPC5 - Electronic control unit E5, OPC5/RET2 - Scania models - P, G, R, T Series (2003-2018); F, K, N Series bus (2004+)
--- OPC5: Read/Write Flash by OBDII/Bench
For more information you can check here: https://www.diagcode.com/udmtrucktool/
<<< Date 24.02.2023 >>>
McLaren Automotive diagnostic software
For Model Speedtail 2019+:
Chassis Control Unit (CCU):
- Align Vehicle Configuration
- Accelerometer Zero
- Suspension Calibration
Occupant Restraints Controller (ORC):
- Configure Occupant Classification System
Camera Monitoring System Left (CMSL)
- CMSL Calibration
Camera Monitoring System Right (CMSR)
- CMSR Calibration. For more information you can check here: https://www.diagcode.com/mclaren/
<<< Date 09.02.2023 >>>
Diag Truck Tool
- Added new functionality - Clear Emission Relevant Codes (ACM301T), EEprom Read/Write - CPC301T, ACM02T and this is absolutely free for all customers of the function. For more information you can check here: https://www.diagcode.com/diagtrucktool/
<<< Date 26.01.2023 >>>
Diag Truck Tool
- Added new functionality - Vmax Change (CPC501T-CPC5) - Actros MP5, Atego, Axor 2018+ Euro 6 and this is absolutely free for all customers of the function. For more information you can check here: https://www.diagcode.com/diagtrucktool/
<<< Date 19.01.2023 >>>
McLaren Automotive diagnostic software
For Model Senna:
Chassis Control Unit (CCU):
- AEF Service Functions
For Model 720s:
Switch Control Unit Gateway (SCUG):
- Steering Column Calibration
- Steering Column Manual Move
For Model 765LT:
Switch Control Unit Gateway (SCUG):
- Steering Column Calibration
- Steering Column Manual Move
For Model GT:
Engine Control Unit (ECU):
- DMTL Diagnostic Module Tank Leakage Test
- Purge System Diagnosis
- Throttle adaption
- Secondary Air Diagnosis
Switch Control Unit Gateway (SCUG):
- Steering Column Calibration
- Steering Column Manual Move
For Model Speedtail 2019+:
Engine Control Unit (ECU):
- Cam Control Diagnosis
- Catalytic Converter Diagnosis
- DMTL Diagnostic Module Tank Leakage Test
- Purge System Diagnosis
- Throttle adaption
- Secondary Air Diagnosis
Body Control Module (BCM)
- Align Vehicle Configuration
Steering Angle Sensor (SAS)
- Fine Tune Zero Position
Switch Control Unit Gateway (SCUG)
- Change Car Configuration
- Steering Column Calibration
- Steering Column Manual Move. For more information you can check here: https://www.diagcode.com/mclaren/
<<< Date 16.01.2023 >>>
Extreme MB Tools
- In the new version of Extreme MB tools, we have added the following new functionalities:
<<<Version 1.0.4.7>>>
1. Added Support for adapting a New or Donor EZS when old one is faulty, broken or missing.
(Easily retrieve Original Hashes from ECU on bench, on car’s fitted with ESL there is no need to remove ESL, data is collected via diagnostic connector with fitted EZS in car)
2. Changed colour scheme of UI to suit new Logo
3. Changed notification period for subscription notifications up to 365 days.
4. Bug fixes. For more information you can check here: https://www.diagcode.com/embt/